Fencing

Safe Fence Electric Hardware

R-40 End Tensioner Begin and end each strand with this part at gate posts or buildings. Holds webbing tight and allows easy re-tightening.

R-55 Tee Tensioner Has three tensioners to be used at all cross fence junctions.

TP-25 Tee-Post Insulator Used on steel tee line posts. When using tee-post for fencing the corners and gate posts should be wood.

RP-25 Round Rod Insulator To be used on fiberglass or steel round rod line posts up to 5/8". Great for temporary pasture separations.

R-24 Splicer A stainless steel spring buckle similar to the tensioner. Used to join rolls of webbing or repair torn webbing in minutes.

R-59 Wire Connector Clamps over the tensioner bar. Connects fence charger to tensioner, strand to strand and burial wire under gates. Use R-28 wire.

R-50 Corner Tensioner Used at all corners or any up and down hill direction change greater than 10 degrees.

R-16 Universal Insulator A polyethylene insulator for wood or plastic line posts in pastures. The lock face holds webbing tight.

R-4 Tee-Posts Cap A perfect cap for the top of a tee-post. Prevents horses from being impaled on the top of a tee-post.

R-12 Gate Handle The best electric gate handle made. Practically unbreakable, the spring compresses for longer life.

R-9 Contact Clamp Used to connect the fence charger to the webbing anywhere in the fence line when a tensioner in inaccessible. Use R-28 wire.

R-28 High Volt Burial Wire Rated at 10,000 volts, Safe-Fence wire will not leak voltage into the ground or posts as will happen with common 110 or 220 burial wire.